注：在运行过程中若发生常规故障（如水压不够等），设备会报警，这时应先按

注：在运行过程中若发生常规故障（如水压不够等），设备会报警，这时应先按下如图5.2-2 所示的按钮，报警器停止鸣叫，然后单击触摸屏上的报警提示（弹出图5.3-5 所示的对话框），找出警告信息（红色字体），根据警告信息进行相关故障的修复（内容见附录一），待故障修复完毕后，单击选中红色告警信息，再按告警复位按钮，复位设备，最后单击确认消除按钮清除告警。若出现严重故障，可以按图5.2-2 所示的“急停”按钮，并通知相关人员对故障进行维修处理

ผลลัพธ์ (อังกฤษ) 1:

Note: in run process in the if occurred General fault (as hydraulic enough,), equipment will alarm, then should first by Xia as Figure 5.2-2 by shows of button, alarm stop tweet, then click touch screen Shang of alarm tips (pop-up figure 5.3-5 by shows of dialogue box), find warning information (red font), according to warning information for related fault of repair (content see Appendix a), stay fault repair finished Hou, click selected red alarm information, again by alarm reset button, reset equipment, Finally click OK to eliminate button to clear the alarm. If there is a serious failure, as shown in Figure 5.2-2 "emergency stop" button, and notify the relevant personnel to repair the fault handling

ผลลัพธ์ (อังกฤษ) 2:

Note: In the event of running a general failure (such as not enough water pressure, etc.), the device will alarm, then you should press the button as shown, the alarm stops shown 5.2-2 tweet, and then click on the touch screen alarm After the prompt (pop-up dialog box shown in Figure 5.3-5) to find out a warning message (red font), the associated fault repair according to the warning information (content see Appendix A), until the fault is repaired, click to select the red alarm information press the alarm reset button to reset the device, then click the button to confirm the elimination of clear warning. If there is a serious fault that can "stop" button as shown in Figure 5.2-2, and notify the relevant personnel to repair the fault handling

ผลลัพธ์ (อังกฤษ) 3:

Note: if the normal failure (such as water pressure is not enough), the device will alarm, and then press the button, the alarm stops, and then click on the 5.3-5 display (red font), to find the warning information (red font), according to the warning information to repair the relevant failure (see Appendix 1), after the completion of the fault repair, click on the red alert information, then press the reset button, and finally click to confirm the removal of the alarm. If there is a serious failure, you can press the "emergency stop" button in figure 5.2-2,And notify the relevant personnel to repair the fault