说明： 1、配电柜底座两端用-40×4镀锌扁钢与接地装置焊接。 2、电

说明：
1、配电柜底座两端用-40×4镀锌扁钢与接地装置焊接。
2、电缆支架上的热镀锌扁钢-40×4沿电缆支架通长敷设,与电缆支架焊接并相互焊接，在配电室四个角处分别用热镀锌扁钢-40×4与接地端子板焊接。
3、电缆支架焊接在预埋Φ12钢筋上。
4、所有接地焊接点必须涂防锈漆两度。
5、配电室与变压器之间的墙不允许开设窗口。
6、其它说明见图E1-01。

ผลลัพธ์ (อังกฤษ) 1:

Description: 1, -40x4 galvanized flat steel used for power distribution Cabinet at both ends of the base weld and grounding device. 2, hot-dip galvanized flat steel cable bracket -40x4 bracket long laying and cable bracket welded and welded each other, respectively in the distribution room four corners use hot-dip galvanized flat steel -40x4 with earthing terminal plates. 3, cable bracket welded on pre-buried φ on the 12 bar. 4, grounding all welds are painted antirust paint twice. 5, the distribution between the transformer and the walls do not allow to open Windows. 6, other notes, as shown in Figure E1-01.

ผลลัพธ์ (อังกฤษ) 2:

Description:
1, power distribution cabinet base at both ends with -40 × 4 galvanized flat steel welded and ground equipment.
2, galvanized flat steel cable bracket -40 × 4 along the length of the cable through the bracket laying, and cable bracket welded and welded to each other, respectively, in the four corners of the power distribution room with hot galvanized flat steel -40 × 4 and ground terminal plate welding.
3, cable bracket welded on steel embedded Φ12.
4, all ground welds must be painted rust twice.
5, the wall between the distribution transformer room and not allowed to open the window.
6, the other is illustrated in Figure E1-01.