假如控制器通电了一段时间，水泵处在停机状态时，给控制器断电后马上重新上

假如控制器通电了一段时间，水泵处在停机状态时，给控制器断电后马上重新上电（时间间隔小于6秒），这时水泵还是处于停机状态，因为控制器断电后，CBB电容放电需要几秒（大概6秒）时间，芯片工作电压很宽，电没放完再次上电时，芯片还在工作，记住的是断电前的状态。

ผลลัพธ์ (อังกฤษ) 1:

If controller power has a time, pumps in downtime State Shi, to controller power Hou immediately again Shang electric (time interval is less than 6 seconds), then pumps also is in downtime State, because controller power Hou, CBB capacitor discharge needs several seconds (probably 6 seconds) time, chip work voltage is wide, electric didn't put finished again Shang electric Shi, chip also in work, remember of is power Qian of State.

ผลลัพธ์ (อังกฤษ) 2:

If the controller is powered on for some time, the pump is in shutdown state, the controller turns off immediately to re-power (time interval of less than 6 seconds), then the pump is at a standstill, because the controller after power failure, CBB capacitor Discharge takes a few seconds (about 6 seconds) time, the chip working voltage is wide, electricity is not discharged when the power again, the chip is still working, remember the status before the power failure.

ผลลัพธ์ (อังกฤษ) 3:

If the controller is energized for a long time, the pump is in a down state, to the controller power immediately after the power on again (time interval is less than 6 seconds), then the water pump is still in shutdown state, because the controller after power failure, the CBB capacitor discharge needs a few seconds (about 6 seconds) time, chip wide voltage, power not put out when power again, still working on chips, remember is the last state.