背板褶皱时受光面不能有重叠，不能乱写，组件背面褶皱深度≤0.5mm,且

背板褶皱时受光面不能有重叠，不能乱写，组件背面褶皱深度≤0.5mm,且长度≤50mm，不超过3处；背板凸起≤0.5mm；背板不允许偏离玻璃

ผลลัพธ์ (อังกฤษ) 1:

Back panel can have no overlapping folds when illuminated, cannot write, back fold depth the components 0.5mm and length ≤ 50mm does not exceed 3; back bulge 0.5mm; not allowed to deviate from the back panel glass

ผลลัพธ์ (อังกฤษ) 2:

Smooth fold back when not overlap that can not scrawl, Rear Components wrinkle depth ≤0.5mm, and the length ≤50mm, not more than 3; back projection ≤0.5mm; not allowed to deviate from the back glass

ผลลัพธ์ (อังกฤษ) 3:

Backplane fold by smooth not overlapping, not scribble, assembly back fold depth is less than or equal to 0.5 mm and 50mm in length is less than or equal to, no more than 3; backplane raised less than or equal to 0.5 mm; backplane does not allow deviation of glass