本预处理器采用内置控制器控制，首先合上预处理器箱体左侧的总电源开关（断

本预处理器采用内置控制器控制，首先合上预处理器箱体左侧的总电源开关（断路器），按下面
板上的电源开关按钮，按钮自动锁住，电源指示灯亮。电源接通后，内置控制器经过初始化（约10
秒钟）以后便进入工作状态。预处理器有手动和自动两种工作方式，可任意选择手动或自动工作方
式。自动工作是和CODmax 分析仪或系统联动的，由分析仪或系统控制预处理器定时工作，工作流
程由内置控制器控制完成。手动状态可以独立操作预处理器各功能键。
注意：
手

ผลลัพธ์ (อังกฤษ) 1:

The preprocessor uses the built-in controller, first preprocessor on the box to the left of main power supply switch (circuit breaker), press
on the Board below the power switch button, the button lock, power light is on. After the power is switched on, the built-in controller is initialized (approximately 10
seconds) to work later. Preprocessor manual and automatic working modes, a choice of manual or automatic
type of work. Or automatic are CODmax Analyzer system, Analyzer or system preprocessor regular work
workflow process controlled by the built-in controller is complete.Manual status can operate independently of the preprocessor function keys.
Note:

ผลลัพธ์ (อังกฤษ) 2:

The pre-processor with built-in controller, first close the main power switch box to the left of the pre-processor (circuit breaker), according to the following
power button panel, automatic lock button and power indicator light. After the power is turned on, the built-in controller is initialized (approximately 10
seconds will enter the working state) later. Preprocessor has both manual and automatic operating mode, you can choose manual or automatic working party
style. Automatic work and CODmax analyzer or system linkage by analyzer or system control preprocessor regular work, work flow
process is controlled by the built-in controller to complete. Manual states can operate independently of each function key pre-processor.
Note:
Hand

ผลลัพธ์ (อังกฤษ) 3:

The pre processor with built-in controller to control the total supply, first close the pre processor box on the left side of the switch (circuit breaker), press the power switch button below
board, automatic lock button, power indicator light. When the power supply is switched on, the built-in controller after initialization (about 10
seconds) after they enter the working state. The pre processor has two types of manual and automatic operation mode, manual or automatic working party
type can be selected arbitrarily. Automatic work and CODmax analyzer or system linkage, or by the analyzer system control pre processor timing work, workflow process is controlled by a built-in controller.Can operate independently of each function key manually pre processor state. Note:

hand